With the rapid development of the hydraulic industry, higher requirements are put forward for the reliability of the hydraulic system. At present, about 70% of the failures in the hydraulic system are caused by oil pollution.

In order to control the pollution degree of the hydraulic system, in addition to installing an oil filter in the hydraulic system, the new oil injected into the system needs to be pre-purified with a BRH series high-precision oil filter, and the hydraulic system can also be circulated and filtered. Purify system oil.

It can not only filter out the impurities in the oil, but also absorb part of the water in the oil

BRH series high-precision oil filter can be used for refilling or regular purification and filtration of various oils. It also has a certain effect on the recovery of dirty oil. It is an ideal energy-saving equipment.

Features

BRH series high-precision oil purifier has the characteristics of lightness and flexibility, convenient movement, simple operation, reliable performance, compact structure, beautiful appearance and convenient maintenance.

Installation and commissioning

Since the equipment is mobile, there is no need to design another installation foundation, just move the equipment to the level ground near the oil tank to be treated or the oil tank.

Connect the oil inlet and outlet pipes of the equipment to ensure that the oil path from the oil tank to the machine is unblocked. Upper fuel filler.

The selection of the power supply line must be able to withstand the maximum current of the equipment during normal operation.

Start the motor, and observe whether the motor is rotating clockwise. If it is not clockwise, please change the phase of the power supply.

Detail display one

Details display two

Use and maintenance

When the oil filter is started, the motor cannot be reversed. After confirming that the motor is running clockwise, it can work normally. After the oil filter has been used for a period of time, the flow rate decreases or the motor noise increases. Check whether the filter element is seriously blocked.

When the pressure reaches 0.4Mpa due to pollutant blockage, the filter element should be replaced in time. If the oil filter is running, but the oil outlet does not produce oil, check whether the motor is turning correctly, whether the seal between the oil tank and the suction port of the oil pump is reliable, and whether the oil suction port is separated from the oil. Surface or oil has been absorbed.

The maintenance and maintenance of the oil filter is very important, so it is necessary to do a good job of daily inspection, so that it can better play its due role in various fields.

Opening a new game with high-quality products, Lifelt will continue to make new contributions to the construction of the fluid environmental protection industry with technology-leading, quality-leading products and a more complete after-sales guarantee system!